To set up a plant pot foundation, only the subsoil has to be level and load-bearing. Many systems can be used with this structure, such as cell towers (5G), floodlight pole, lightning protection mast and many more.
in a plant plot
To set up a plant pot foundation, only the subsoil has to be level and load-bearing. Many systems can be used with this structure, such as cell towers (5G), floodlight pole, lightning protection mast and many more.
Below you can see an installation example of a STEEL-ROOT® foundation in a plant pot:
To set up the plant pot foundation the ground only needs to be prepared flat and sustainable.
Easy assembly of the STEEL-ROOT® foundation on the prepared ground. The exact alignment of the STEEL-ROOT® foundation is done by relining the foot plates with grit or sand.
After inserting the paving tiles as well as the side walls, the STEEL-ROOT® foundation in a plant pot is completely assembled.
Now the wiring can be done.
Afterwards the plant pot is filled with a mineral mixture.
Pulling the wires into the mast and attaching the further mast segments to the basic mast. Due to the folding hinge these steps can be done at a comfortable working height.
Raising the mast with the excavator. Alternatively the mast can be raised with a hydraulic system.
A strong connection between the STEEL-ROOT® foundation and the mast is produced. The installation of the mast system is complete. Finally the installation of the antennas can be done.
Upon request you will receive our STEEL-ROOT® foundations in a plant pot completely pre-assembled. Get in touch with us.
